EFL5550 E-flite Radian XL 2.6m Manual

Radian

XL 2.6m

Model Assembly Continued

Horizontal Tail Installation

1. Slide the two horizontal tail tubes (A) into the holes on the vertical ﬁn as

shown.

2. Install the 2 piece (left and right) horizontal stabilizer as shown.

3. Secure the two horizontal tail pieces in place using the included

(2) 2.5 x 5.5mm (B) and (2) 2.5 x 4mm (C) screws.

Wing Assembly

1. Slide the 2 wing spar joiners (A) and the 1 tab joiner (B) into the center

section of the wing as shown.

2. Install the wing tip over the spar joiners and tab.

3. Fasten with (3) 3 x 16mm screws (C).

4. Repeat steps 1-3 for the other wing tip.

B C