EFL5550 E-flite Radian XL 2.6m Manual

EN
Model Assembly
1. Slide the rudder’s CA hinges (A) in the hinge slots (B) of the vertical fin.
2. Bend the hinges by turning the rudder left, then carefully apply drops of thin
CA to each hinge in the right side of each slot.
3. Let the CA wick into the hinge for a few seconds and then turn the rudder to
the right and apply drops of CA in the left side of each slot.
4. Let the CA dry for a few minutes and then attach the clevis to the Rudder
control horn.
Tip: Use a credit card or thin piece of cardboard for proper rudder/vertical fin
spacing.
A
B
Required Adhesives:
Thin CA
Rudder Installation
Clevis Installation
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired hole in
the control horn.
• Move the tube to hold the clevis on the control horn.
1.
2.
3.
4.
5.
6.
Elevator
Flaps
Tail wheel
5