EFL8450 Razorback Manual

EN
Propeller Installation
IMPORTANT: Install the propeller after all system setups are completed to
reduce the chance of accidental propeller strike.
1. Install back side of propeller hub (A), propeller (B), and front side propeller
hub (C) onto the motor shaft (D). The propeller size numbers (10.5 x 8) must
face out from the motor for correct propeller operation.
2. Install the spinner nut (E) to secure the propeller into place. Use a small
screw driver or hex wrench inserted into the small hole (Inset) and turn
clockwise to secure it into place.
Disassemble in reverse order.
Model Assembly Continued
E
D
C
B
A
Drop Tank, Rocket Tubes and Bomb Installation
1. Clip the bombs (A) and center drop tank (B) to the brackets.
2 Slide the Rocket Tubes (C) into the rails on each wing.
Check the Center of Gravity with the drop tanks installed.
See the Adjusting the Center of Gravity instructions for more information.
Drop
Tank
,
Rocket
Tubes
and
Bomb
Installatio
n
1.
C
lip the bombs
(A)
an
d
center
d
rop tan
k
(B)
to t
h
e
b
rac
k
ets.
2 Slide the Rocket Tube
s
(C) into the rails on each wing.
Check the Center of Gravity with the drop tanks installed
.
See the Adjusting the Center of Gravity instructions for more information
.
A
B
C
7