User Manual

7E-flite Habu 32 EDF ARF Assembly Manual
Aileron Servo Installation
Required Parts
Wing panel (right and left)
Transmitter Receiver
Receiver battery Silicone tubing
Metal clevis (4) 2mm nut (4)
Servo with hardware (MC35) (2)
Servo extension, 3-inch (76mm) (2)
Threaded rod, 2mm x 25mm(2)
Hardwood block, 13mm x 10mm x 7mm (4)
2mm x 8mm self-tapping screw (8)
Required Tools and Adhesives
Ruler Phillips screwdriver: #1
Scissors Hobby knife with #11 blade
String Pencil
Thin CA 5-minute epoxy
Mixing cup Mixing stick
Drill Drill bit: 5/64-inch (2mm)
Rotary tool Sanding drum
Medium grit sandpaper
Before starting the installation of the servos, we
recommend centering the trims and sticks on your
transmitter. If using a computer radio, make sure
to reset a model memory and name it for this
particular model. We also recommend binding the
transmitter and receiver at this time following the
instructions provided with your radio system.
 1. Prepare the aileron servo by installing the
rubber grommets and brass eyelets as shown in the
radio or servo instructions. Center the aileron servo
using the radio system. Use side cutters to remove
any arms from the horn that may interfere with the
operation of the servo.
The aileron linkage will be connected to the hole
in the servo horn 3/8-inch (10mm) from the center
of the arm as illustrated in the photo above.
 2. Secure a 3-inch (76mm) servo extension to the
aileron servo lead using string or a commercially
available connector.
 3. Repeat steps 1 and 2 to prepare a second
aileron servo. Note the servos will be mirror
images of each other.
 4. Remove the cover from the wing for the flap
and aileron servos. Set the cover aside for the flap
servo at this time.