User Manual

31E-flite Habu 32 EDF ARF Assembly Manual
 8. Use the radio system to move the nose gear
retract to the UP position. Use a 1.5mm hex wrench
to loosen the screw on the steering arm and wheel
collar to remove the strut from the mechanism.
We have designed the main gear struts to work
with both the fixed gear and the suggested
retracts. These struts are designed for the
weight and speeds of the Habu. Use the struts
supplied with the kit for the retract assembly.
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.
 9. Use a 1.5mm hex wrench to secure the steering
arm by tightening the setscrew on the lower flat
of the nose gear strut. Make sure the arm is
positioned as shown in the photo.
 10. Install the supplied nose gear strut in the
retract mechanism and tighten the setscrews using
a 1.5mm hex wrench. The setscrews should align
with the flat spots on the nose gear leg.
 11. Connect the clevis without the tubing to the
steering arm of the nose gear assembly.
Cut a 1/2-inch (13mm) piece of silicone tubing
and slide it on a 2.5mm hex wrench. The 3mm
screw can then be placed in the tubing and
against the hex wrench so the screw can be
easily installed to secure the landing gear.
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.