User Manual

12 E-flite Habu 32 EDF ARF Assembly Manual
 5. Use 5-minute epoxy to glue the 13mm x 10mm
x 7mm hardwood block to the servo cover. Make
sure to glue the 10mm x 7mm end to the surface
of the plate. Allow the epoxy to fully cure before
proceeding.
 6. Use a rotary tool and small sanding drum to
make a notch in the block for the servo lead. Check
the fit of the servo to make sure the servo lead can
clear the mounting block.
 7. Position the flap servo with the grommets resting
on the first mounting block and the servo parallel
to the line on the cover. Use a pencil to mark the
location for the remaining servo mounting block.
 8. Use 5-minute epoxy to glue the remaining block
to the cover. Don’t forget to roughen the end of the
block as shown in step 6.
 9. Position the servo between the two blocks.
Leave a small gap between the servo and servo
cover so vibrations from the airframe are not
transferred directly into the servo. Use a pencil
to mark the locations for the four servo mounting
screws on the blocks.
 10. Use a drill and 5/64-inch (2mm) drill bit to
drill the holes for the mounting screws. Use care not
to enlarge the holes any larger than the drill bit.