F4U-4 Corsair 1.2M Manual

EN
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the Spektrum AR636 manual for
adjustment of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Horns Arms
Elevator
Ailerons
Flaps
Rudder
More control throw Less control throw
Propeller Installation
IMPORTANT: It is recommended to install the propeller after all system setups
are completed to reduce the chance of accidental propeller strike.
1. Install back side of propeller hub (A), propeller (B), and front side propeller
hub (C) onto the motor shaft (D). The propeller size numbers (10.5 x 8) must
face out from the motor for correct propeller operation.
2. Install the spinner nut (E) to secure the propeller into place. Use a small
screw driver or hex wrench inserted into the small hole (Inset) and turn
clockwise to secure it into place.
Model Assembly Continued
E
C
A
D
B
7