User Manual

Prefl ight Checklist
Installing the Flight Battery and Arming the ESC

1. Charge the fl ight battery.
2. Turn on the transmitter.
3. Install the fl ight battery in the aircraft
(once it has been fully charged).
4. Make sure the linkages move freely.

5. Perform the Control Direction Test with
the transmitter.
6. Adjust the center of gravity.
7. Find a safe and open area.
8. Plan fl ight appropriate for fl ying location.
Arming the ESC also occurs after binding
as previously described, but subsequent
connection of a fl ight battery requires the
following steps.
CAUTION: Always keep hands
away from propeller. When armed,
the motor will turn the propeller in
response to any throttle movement.
CAUTION: Always disconnect the
Li-Po battery from the aircraft
receiver when not fl ying to avoid
over-discharging the battery. Batteries
discharged to a voltage lower than the
lowest approved voltage may become
damaged, resulting in loss of
performance and potential fi re when
batteries are charged.
2
1
3
Lower throttle and
throttle trim to
lowest settings.
Power ON the
Transmitter,
then wait 5
seconds
Secure the battery
to the hook and
loop strip on the
battery holder.
Connect the
battery to the
ESC, noting proper
polarity.
Continuous LED
7
EN