User Manual

7
EN
Flight Battery Installation and ESC Arming
ArmingtheESCalsooccursafterbindingas
previously described, but subsequent connection
of a flight battery requires the following steps.
Itisnormalforlinearservostomakenoise.Noise
is not an indication of a faulty servo.
CAUTION: Alwayskeephandsaway
from the propeller. When armed, the motor will
turn the propeller in response to any throttle
movement.
CAUTION:AlwaysdisconnecttheLi-Po
battery from the aircraft receiver when not
flying to avoid over-discharging the battery.
Batteries discharged to a voltage lower than
the lowest approved voltage may become
damaged, resulting in loss of performance and
potential fire when batteries are charged.
IMPORTANT: The camera will continue to
discharge the battery until the battery is
disconnected.
3
2
1
1-2-3-4-5 Sec.
Lower throttle and
throttle trim to
lowest settings.
Power ON the
transmitter, then
wait 5 seconds.
Connect the
batterytotheESC,
noting proper
polarity.
Continuous LED
Securethebattery
tothehookand
loop strip on the
battery holder.
Refer to the
Center of Gravity
Adjustment
instructions for
the battery’s
position.
FLY...