User Manual

4
EN
CAUTION: Only use a charger specifically
designed to charge a Li-Po battery. Failure to do so
could result in fire, causing injury or property
damage.
CAUTION:Neverexceedtherecommended
charge rate.
CAUTION: Alwaysdisconnecttheight
battery from the charger immediately upon
completion of charging.
Chargingafullydischarged(notover-discharged)
150mAhbatterytakesapproximately45minutesat
thecharger’s300mAchargerate.TheLEDgoesout
when the charge is complete.
Flight Battery Charging
USB Li-Po
Charger
EFLC1008
SOLID RED LED
–Charging
DC Input:5.0V 350mA
DC Output:4.2V 300mA
LED OFF
–Charge
Complete
USB Li-Po
Charger
EFLC1008
SOLID RED LED
–Charging
DC Input:5.0V 350mA
DC Output:4.2V 300mA
LED OFF
–Charge
Complete
USB Li-Po
Charger
EFLC1008
SOLID RED LED
–Charging
DC Input:5.0V 350mA
DC Output:4.2V 300mA
LED OFF
–Charge
Complete
LED Indications
CHARGING (SolidRed) ..............................
MAX CHARGE (off) ...................................
45
MIN.

1. Charge flight battery.
2. Install flight battery in aircraft (once it
hasbeenfullycharged).
3. Bind aircraft to transmitter.
4.Makesurelinkagesmovefreely.
5. Perform Control Direction Test with
transmitter.
6.Setdualrates.

7.Adjustcenterofgravity.
8.PerformaradiosystemRangeCheck.
9. Find a safe and open area.
10. Plan flight for flying field conditions.
11.ChecktheoperationofFPVsystem.
12.Setflighttimerfor5minutesforfirst 
flight.
Preflight Checklist