User Manual

3
EN
To register your product online, go to www.e-fliterc.com
15.3in(389mm)
14.8in(376mm)
.84 oz
(24g)
Specifications
Box Contents
RTF Includes
Installed
BNF Includes
Motor:
6mm Brushed
Receiver:
3-ChRx/ESCDSMX
(PKZU1152)
Ultra Micro FPV camera:
wide angle lens, Integrated
CP antenna, Compatible
with5.8GHzFatShark
systems
47mm
Dual Rates and Timer Settings
Dual Rates
High Low
100 % 70%
Flight Timer
Setting
First Flight
5 Min.
6 Min.
Before first flights, or in the event of a crash,
make sure the control surfaces are centered
when the transmitter controls and trims are
neutral. The transmitter sub-trim must be set to
zero.Adjustthelinkagesmechanicallyifthecontrol
surfaces are not centered.
Control Centering
Elevator
Control Horn Settings
Rudder
Li-Po BATTERY PACK
7.4V 760mAh
Recommended Transmitter:
Spektrum
™
DSM2
®
/DSMX
®
full
range(DX4eandup)
Li-Po BATTERY PACK
7.4V 760mAh
The CG location is 47mmbackfromtheleading
edge at the wing root. This has been determined
withtheincluded1S150mAh3.7VLi-Pobattery
correctly installed. Balance the model on the
edge of a metal ruler to find the Center of
Gravity. Place the ruler on the underside of the
center wing rib.