User Manual
10
EN
Power Components Service
I
n
s
t
a
l
l
R
e
m
o
v
e
CAUTION: DO NOT handle propeller parts
while the fl ight battery is connected. Personal
injury could result.
Disassembly
1. Disconnect the battery from the
ESC/receiver.
2. Carefully cut at the seam on each nacelle and
remove the bottom half.
3. Hold the prop shaft using needle-nose
pliers or hemostats.
4. Turn the propellers counterclockwise (facing
the front of the model) to remove. Turn the
propeller clockwise to install.
5. Hold the nut (A) on the end of the prop
shaft using needle-nose pliers or
hemostats.
6. Turn the gear on the shaft to remove the nut.
7. Gently pull the shaft (B) from the gearbox (C)
and make sure the washer (D) and two
bushings (E) are not lost.
8. Disconnect the motor from the ESC/
receiver.
9. Gently push the motor out of the
gearbox and remove the motor
through the bottom of the nacelle.
NOTICE: DO NOT remove the gearbox from
the aircraft. Damage to the aircraft will result.
Assembly
Assemble the aircraft using the instructions
above in reverse order.
• Correctly align the prop shaft gear with the
pinion gear on the motor.
• Connect the motor to the ESC/receiver so
that the powered motor turns the propeller
counterclockwise (facing the front of the model).
• Make sure the propeller size numbers (112 x 90)
face away from the motor (see illustration).
• Attach the spinner to the propeller using foam-
compatible CA (Cyanoacrylate adhesive).
• Assemble each nacelle into place and secure with
foam-compatible CA.
112 x 90
E
C
D
112 x 90
A
B