User manual

3
EN
To register your product online, go to www.e-fl iterc.com
Installed
Motor: 180BL 3000Kv Brushless
Outrunner (EFLUM180BLB)
Receiver :
DSM2 6 Ch Ultra Micro AS3X
®
Receiver BL-ESC (SPMAS6410LBL)
(2) 2.3-Gram Performance Linear Long
Throw Servo (SPMSA2030L)
Needed to Complete
Recommended Battery: 200mAh 2S
7.4V 30C Li-Po, 26AWG (EFLB2002S30)
Recommended Battery Charger:
Celectra
™
2S 7.4V DC Li-Po Charger
(EFLUC1007)
Recommended Transmitter:
Spektrum
™
DSM2
®
/DSMX
®
full range
with dual-rates (DX4e and up)
18.8 in (400mm)
16 in (523mm)
3.03 oz
(86 g)
Transmitter and Receiver Binding ...........................4
Low Voltage Cutoff (LVC) ........................................4
ESC/Receiver Arming, Battery Installation and
Center of Gravity ....................................................5
Control Direction Tests ...........................................6
Control Centering ..................................................7
Control Horn Settings .............................................7
Dual Rates .............................................................7
DX4e and DX5e Expo Activation and Deactivation ..8
Flying Tips and Repairs ..........................................9
Post Flight Checklist ..............................................9
Power Components Service .................................10
Troubleshooting Guide .........................................11
Limited Warranty .................................................12
Warranty and Service Information ........................14
IC Information ......................................................14
FCC Information ...................................................14
Compliance Information for the European Union ...14
Replacement Parts ...............................................54
Optional Parts and Accessories ............................55
Table of Contents
Specifi cations
9
1. Charge fl ight battery.
2. Install fl ight battery in aircraft (once it
has been fully charged).
3. Bind aircraft to transmitter.
4. Make sure linkages move freely.
5. Perform Control Direction Test with
transmitter.
9
6. Set dual rates and expos.
7. Adjust center of gravity.
8. Perform a radio system Range Check.
9. Find a safe and open area.
10. Plan fl ight for fl ying fi eld conditions.
Prefl ight Checklist
Wing Area: 85 sq. in.
(547 sq. cm.)