User Manual

14
EN
Troubleshooting Guide
Problem Possible Cause Solution
Aircraft will not
respond to throttle
but responds to other
controls
Throttle stick and/or throttle trim too high Reset controls with throttle stick and throttle
trim at lowest setting
Throttle channel is reversed Reverse throttle channel on transmitter
Motor disconnected from receiver Open fuselage and make sure motor is
connected to the receiver
Extra propeller noise
or extra vibration
Damaged propeller, spinner or motor. Replace damaged parts
Prop screw is too loose Tighten the prop screw
Prop out of balance Balance the prop
Reduced fl ight time
or aircraft underpow-
ered
Flight battery charge is low Completely recharge fl ight battery
Propeller installed backwards Install propeller with numbers facing forward
Flight battery damaged Replace fl ight battery and follow fl ight battery
instructions
Flight conditions may be too cold Make sure battery is warm before use
Battery capacity too low for fl ight
conditions
Replace battery or use a larger capacity
battery
LED on receiver
fl ashes and aircraft
will not bind to
transmitter (during
binding)
Transmitter too near aircraft during binding
process
Power off transmitter, move transmitter a larger
distance from aircraft, disconnect and recon-
nect fl ight battery to aircraft and follow binding
instructions
Bind switch or button not held long enough
during bind process
Power off transmitter and repeat bind process.
Hold transmitter bind button or switch until
receiver is bound
Problem Possible Cause Solution
Control surfaces not
at neutral position
when transmitter
controls are at neutral
Control surfaces may not have been
mechanically centered from factory
Center control surfaces mechanically by
adjusting the U-bends on control linkages
Aircraft was moved after the fl ight battery
was connected and before sensors
initialized
Disconnect and reconnect the fl ight battery
while keeping the aircraft still for 5 seconds
Model fl ies incon-
sistently from fl ight
to fl ight
Trims are moved too far from neutral
position
Neutralize trims and mechanically adjust
linkages to center control surfaces
Controls oscillate in
fl ight (model rapidly
jumps or moves)
Propeller is unbalanced causing excessive
vibration
Remove propeller and rebalance or replace it
if damaged
Prop screw is too loose, causing
vibration
Tighten the prop screw
AS3X