User Manual

CAUTION: Always disconnect the flight battery
before performing motor service.
Motor Removal
1. Disconnect and remove the flight battery from the
aircraft.
2. Remove the propeller.
3. Remove the propeller adapter from the motor.
4. Using a sharp knife, carefully cut the tape along the
base of the rear top hatch and remove the hatch.
5. Unplug the motor lead from the ESC and peel back
tape securing the motor lead.
6. Remove four 5mm screws from the motor mount and
pull the motor and mount away from the aiframe.
7. Remove the 8mm screw from the motor mount and
slide the motor out of the mount.
Assemble in reverse order.
CAUTION: Always disconnect the flight battery
before performing propeller service.
1. Disconnect and remove the flight battery from the aircraft.
2. Remove the 5mm washer head propeller screw.
3. Pull the propeller from the propeller adapter.
4. Place the new propeller on the propeller adapter with
the raised numbers on the prop facing toward the
motor and the front of the aircraft.
5. Install the propeller screw. DO NOT overtighten the screw as
damage to the propeller and propeller adapter may result.
Never use thread locking compound on the propeller
screw or the propeller adapter.
Changing the Propeller
10
EN
AS3X Troubleshooting Guide
Problem Possible Cause Solution
Oscillation in fl ight
Damaged propeller Replace propeller
Propeller out of balance Balance the propeller
Motor vibration Replace parts or correctly align all parts and tighten fasteners as needed
Loose receiver Align and secure receiver in fuselage
Loose aircraft controls Tighten or otherwise secure parts (servo, linkage, horn and control surface)
Worn parts Replace worn parts (especially propeller or servo)
Irregular servo movement Replace servo
Inconsistent fl ight
performance
Trim is not at neutral If you adjust trim more than 8 clicks, adjust the linkage to remove trim
Sub-trim is not at neutral No sub-trim is allowed. Adjust the servo linkage
Aircraft was not kept immobile for
5 seconds after battery connection
With the throttle stick in lowest position. Disconnect battery,
then reconnect battery and keep the aircraft still for 5 seconds
Motor Service