User Manual

12
EN
Troubleshooting Guide
Problem
Possible Cause Solution
•Aircraftwillnotrespond
to throttle but responds to
other controls
•Throttlenotatidleand/orthrottle
trim too high.
•Throttlechannelisreversed
•Resetcontrolswiththrottlestick
and throttle trim at lowest setting
•Reversethrottlechannelon
transmitter
•Extrapropellernoiseor
extra vibration
•Damagedpropellerandspinner
or motor
•Replacedamagedparts
•Reducedighttimeor
aircraft underpowered
•Flightbatterychargeislow
•Propellerdamaged
•Flightbatterydamaged
•Flightconditionsmaybetoocold
•Batterycapacitymaybelowfor
flight conditions.
•Completelyrechargeightbattery
•Replacedamagedparts
•Replaceightbatteryandfollow
flight battery instructions
•Makesurebatteryiswarmbefore
use
•Replacebatteryorusealarger
capacity battery
•LEDonreceiverashes
rapidly and aircraft will
not link to transmitter
•Lessthana5-secondwaitafter
powering transmitter and before
connecting flight battery to aircraft
•Transmittertoonearaircraft
during binding process
•Aircraftnotboundtotransmitter
•Aircraftboundtodifferentmodel
memory (ModelMatch radios only)
•Lowchargeintransmitter
batteries
•Disconnectthenreconnectight
battery to aircraft
•Movepoweredtransmitterafew
feet from aircraft, disconnect and
reconnect flight battery to aircraft
•Bindtransmittertoaircraftreceiver
•Selectcorrectmodelmemoryon
transmitter
•Replaceorchargetransmitter
batteries
•Controlsurfacedoesnot
move
•Controlsurface,controlhorn,
linkage or servo damage
•Wiredamagedorconnections
loose
•Flightbatterychargeislow
•Controltrimoutofadjustment
•Pushrodstuckondriedpaintor
decal
•Replaceorrepairdamagedparts
and adjust controls
•Doacheckofwiresand
connections, connect or replace as
needed
•Fullyrechargeightbattery
•Adjusttrimstorestorefullcontrol
•Freepushrodfrompaint/decal
•Controlsreversed
•Transmittersettingsreversed •DotheControlDirectionTestand
adjust controls on transmitter
appropriately
•Motorlosespower
•Damagetomotor,orpower
components
•Doacheckofbatteries,transmitter,
receiver, ESC, motor and wiring for
damage (replace as needed)
•Motorpowerpulsesthen
motor loses power
•ESCusesdefaultsoftLowVoltage
Cutoff (LVC)
•Rechargeightbatteryorreplace
battery that is no longer performing
•Motor/ESC is not armed
after landing
•OverCurrentProtection(OCP)
stalls motor when the transmitter
throttle is set high and the
propeller cannot turn
•Fullylowerthrottleandthrottletrim
to arm ESC