User Manual

10
EN
Service of Power Components
Disassembly
Propeller
•Removebatteryhatchbyslidingitforward,
then up and away from the fuselage.
•Removescrew,spinner,propellerandback-
plate from the motor shaft. Figure A.
•Carefullyremovespinnerfrompropellerand
backplate. Figure B.
Note: Since the propeller and spinner are
glued together, glue residue will need to be
cleaned from the spinner or propeller when
these parts are used again.
Motor and Firewall
•Remove2screws,rewallandmotorfromthe
fuselage motor mount. Figures E, F and G.
Note: The motor magnet will attract screws to
the motor.
•Removetopscrewfromtherewallandmotor.
Figure H.
• DisconnectmotorwireconnectorfromESC/
receiver connector. Figure I.
Assembly
Motor and Firewall
•ConnectmotorwireconnectortotheESC/
receiver connector so wire colors align.
Figure I.
•Installmotorinrewallusingascrewputin
the top of the firewall. Figure H.
•Attachrewalltofuselagemotormountusing
2 screws. Figure E.
Propeller
•Assemblebackplate,propellerandspinnerus-
ing foam-safe CA. Align then glue spinner over
propeller and backplate.
Figures A, B and C.
Note: Numbers on the propeller must face out
from fuselage for correct propeller operation.
Figures C and D.
•Installassembledbackplate,propellerand
spinner on motor shaft using a screw.
Figure A.
•Putfoambatteryhatchonthefuselageand
slide it back to fully engage the fuselage.
•Ifneeded,keepthewheelpantsfromturningonthelandinggearbyputtingasmall
amount of foam-safe CA glue on the end of the landing gear wire.
•Whenthefuselagemustbeopenedforaccesstoservosorreceiver,cuttapeordecals
to open the canopy hatch.
Note: Removing tape or decals will remove paint from the fuselage.
CAUTION: DO NOT handle propeller parts while the flight battery is connected.
Personal injury could result.