User Manual

Control Horn and Servo Arm Settings

The table to the right shows the factory settings for the control horns and servo

arms. Fly the aircraft at factory settings before making changes.

NOTICE: If control throws are changed from the factory settings, the AR636

gain values may need to be adjusted. Refer to the Spektrum AR636 manual for

adjustment of gain values.

After ﬂ ying, you may choose to adjust the linkage positions for the desired

control response. See the table to the right.

Horns Arms

Elevator

Ailerons

Flaps

Rudder

More control throw Less control throw

Propeller Installation

IMPORTANT: It is recommended to install the propeller after all system setups

are completed to reduce the chance of accidental propeller strike.

1. Install spinner back plate (E), Propeller (D) and collet (C) onto motor shaft (F).

The propeller size numbers (10.5 x 8) must face out from the motor for

correct propeller operation.

2. Tighten collet by using a small screw driver or hex wrench inserted into

small hole (Inset).

3. Align and install spinner (B) with small screw (A).

Model Assembly Continued