User Manual

8 E-flite Habu 32 EDF ARF Assembly Manual
 5. Use a pencil to draw two lines on the cover. The
first line is along the bottom of the cover, 3/32-inch
(2.5mm) from the edge. The second line is 7/8-
inch (22mm) from the side of the cover as shown.
This will center the servo horn in the slot when
using the recommended servos.
 6. Sand the 10mm x 7mm end of the block using
medium grit sandpaper. This will be the end glued
to the plate in the next step.
 7. Use 5-minute epoxy to glue the 13mm x 10mm
x 7mm hardwood block to the servo cover. Make
sure to glue the 10mm x 7mm end to the surface
of the plate. Allow the epoxy to fully cure before
proceeding.
 8. Use a rotary tool and small sanding drum to
make a notch in the block for the servo lead. Check
the fit of the servo to make sure the servo lead can
clear the mounting block.
 9. Position the aileron servo with the grommets
resting on the first mounting block and the servo
parallel to the line on the cover. Use a pencil
to mark the location for the remaining servo
mounting block.
 10. Use 5-minute epoxy to glue the remaining
block to the cover. Don’t forget to roughen the end
of the block as shown in step 6.