User Manual

48 E-flite Habu 32 EDF ARF Assembly Manual
Programs for the Habu using the DX8 are available
for download on the Spektum website.
 5. Use scissors to cut a small piece of hook and
loop tape. Use the tape to secure the receiver
in the fuselage.
 6. Use scissors to cut a small piece of hook and
loop tape. Use the tape to secure the remote
receiver in the fuselage.
 7. Route the lead for the retracts through the
fuselage. Routing it through the tray the nose gear
is mounted to and along the bottom of the fuselage
will keep the installation clean. Secure any loose
leads with tie wraps (not included).
Use a #1 Phillips screwdriver to remove the nose
gear cover so there is better access for routing the
retract leads. Replace after routing the leads.
Motor Battery Installation
Required Parts
Fuselage assembly Hook and loop tape
Motor battery Hook and loop strap
Fan cover
Required Tools and Adhesives
Scissors Phillips screwdriver: #1
 1. Apply the hook and loop tape to the bottom of the
battery. This will keep the battery from sliding in the
fuselage which could change the center of gravity.
 2. Apply the mating hook and loop tape to the
battery tray in the fuselage.