User Manual

40 E-flite Habu 32 EDF ARF Assembly Manual
 12. Slide the piece of silicone tubing on a metal
clevis. Thread a 2mm nut then the clevis on the end
of the pushrod inside the fuselage. Connect the
clevis to the elevator servo horn.
It may be necessary to remove the horn from the
elevator servo using a #1 Phillips screwdriver to attach
the clevis to the horn. Make sure the servo is centered
and the horn is perpendicular to the servo as shown
in step 1 when reattaching the horn to the servo.
 13. Remove the tape that holds the elevator to the
stabilizer. Connect the clevis to the elevator control
horn. Adjust the clevises so the elevator is centered
when the elevator servo is centered using the radio
system. Use pliers to tighten the 2mm nuts against
the clevises and slide the silicone tubing over the
forks of the clevis to prevent the clevis from opening
accidentally in flight.
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.
 14. Repeat steps 3 through 13 to install the
remaining elevator servo and linkage. The pushrod
support brace will be assembled using the base
and R1 and R2 standoffs as shown in the following
photos. R2 will be positioned so it is near the hole
closest to the edge of the base.
 15. Secure the Y-harness to the elevator servo leads
using string or a commercially available connector.