User Manual

38 E-flite Habu 32 EDF ARF Assembly Manual
Elevator Servo Installation
Required Parts
Fuselage assembly Servo with hardware (MC35) (2)
Y-harness Metal clevis (4)
2mm nut (4) Silicone tubing
Pushrod support base (2)
Pushrod support standoff, L1 and L2
Pushrod support standoff, R1 and R2
2mm x 8mm self-tapping screw (4)
Pushrod wire, 16
1
/
4
-inch (412mm) (2)
Required Tools and Adhesives
String Scissors
Thin CA Medium CA
CA accelerator Pliers
Hobby knife with #11 blade
Phillips screwdriver: #1
 1. Prepare the elevator servo by installing the
rubber grommets and brass eyelets as shown in
the radio or servo instructions. Center the elevator
servo using the radio system. Use side cutters to
remove any arms from the horn that may interfere
with the operation of the servo.
The elevator linkage will be connected to the hole in
the servo that is 3/8-inch (10mm) from the center
of the arm as illustrated in the photo above.
 2. Repeat step 1 to prepare a second elevator
servo. Note the servos will be identical.
The screws for the elevator servo will go in at a slight
angle so they can be accessed by the screwdriver.
 3. Use a #1 Phillips screwdriver to thread a
servo mounting screw into the mounting holes for
the elevator servo. Remove the screw after cutting
the threads in the plywood.
 4. Place 2–3 drops of thin CA in each of the
holes. This will harden the threads made by the
screws making them more secure when the elevator
servo is installed.
 5. Install the elevator servo in the fuselage using the
hardware provided with the servo and a #1 Phillips
screwdriver. The servo output faces the front of the
fuselage. Guide the lead from the servo over the
top of the intake and to the front of the fuselage.