User Manual

28 E-flite Habu 32 EDF ARF Assembly Manual
 8. Connect the clevis without the tubing to the
steering arm of the nose gear assembly.
Cut a 1/2-inch (13mm) piece of silicone
tubing and slide it on a 2.5mm hex wrench.
The 3mm screw can then be placed in the
tubing and against the hex wrench so it can be
easily installed to secure the landing gear.
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.
 9. Secure the nose gear assembly in the fuselage
using four 3mm x 8mm socket head screws.
 10. Remove the horn from the servo and attach
the clevis to the horn. Place the horn on the servo
and check that the steering is centered when the
steering servo is centered. Once the linkage is set,
tighten the 2mm nut against the clevis using pliers
so the clevis doesn’t vibrate loose. Slide the silicone
over the forks of the clevis and install the screw
to secure the servo horn to the servo using a #1
Phillips screwdriver.
 11. Attach the nose gear cover to the fuselage
using a #1 Phillips screwdriver and the four 2mm x
8mm self-tapping screws removed in step 1.
Add clear tape to both sides of the nose gear
door to help secure it to the fuselage.
 12. Select the correct adapter that fits to the
landing gear strut. Insert two adapters in either side
of the hub of the wheel.