User Manual

24 E-flite Habu 32 EDF ARF Assembly Manual
Optional Main Landing Gear Doors
Required Parts
Wing assembly (right and left)
Transmitter Receiver
Receiver battery Landing gear door (2)
2mm x 8mm self-tapping screw (8)
Landing gear door block (4)
Required Tools and Adhesives
Rotary tool Sanding drum
Sanding block Medium grit sandpaper
Ruler Pencil
Pin vise Drill
Canopy glue Drill bit: 1/16-inch (1.5mm)
Thin CA Side cutter
Phillips screwdriver: #0
Note: The installation of the landing gear doors
is optional and they can be installed at any
time during the life of your model.
 1. Use a pencil to draw a centerline on the
unpainted side of the landing gear door.
 2. Draw two lines on the door that are 7/8-inch
(22mm) and 2
5
/
8
-inch (65mm) from the top edge
of the landing gear door as the center lines for the
mounting blocks.
 3. Use a pin vise and 1/16-inch (1.5mm) drill bit
to drill four holes in the landing gear door that are
3/16-inch (5mm) from the centerline along the
lines drawn in the previous step.
 4. Use a straight edge or ruler to lightly bend the
landing gear door so it will rest tightly against the
wing when the gear are retracted. Work slowly
to avoid cracking the paint on the outside of the
landing gear door.
 5. Locate the landing gear door blocks. Use a
sanding block and medium grit sandpaper to sand
an angle on the notched side so the block will rest
flat against the angle of the landing gear door.
Prepare both blocks at this time.