User Manual

13E-flite Habu 32 EDF ARF Assembly Manual
 11. Apply 2–3 drops of thin CA in each hole
drilled. Also saturate the front and rear of the
block using thin CA to harden the block. This will
help keep the block from splitting when the servo
mounting screws are installed.
Do not use a CA accelerator. Using an
accelerator will not allow the CA to soak into
the fibers of the wood, hardening the blocks.
 12. Use the screws provided with the servo and a
#1 Phillips screwdriver to attach the servo to the
mounting blocks.
 13. Apply 2–3 drops of thin CA in each of the flap
servo cover mounting holes. This will harden the
surrounding wood, making the screws more secure
when they are installed.
Place a piece of low-tack tape on the flap servo lead so
it can be identified easily from the aileron servo lead.
 14. Tie the end of the string around the end of
the flap and aileron servo leads. Use the string
to pull the leads through the wing and out at the
root rib as shown.
Use low-tack tape to tape the flap and aileron
servo connectors together. This will make
them easier to pull through the wing.