User Manual

11E-flite Habu 32 EDF ARF Assembly Manual
Flap Servo Installation
Required Parts
Wing panel (right and left)
Transmitter Receiver
Receiver battery Silicone tubing
Metal clevis (4) 2mm nut (4)
Servo with hardware (MC35) (2)
Threaded rod, 2mm x 25mm (2)
Hardwood block, 13mm x 10mm x 7mm (4)
2mm x 8mm self-tapping screw (8)
Required Tools and Adhesives
Ruler Phillips screwdriver: #1
Scissors Hobby knife with #11 blade
String Pencil
Thin CA 5-minute epoxy
Mixing cup Mixing stick
Drill Drill bit: 5/64-inch (2mm)
Low-tack tape Rotary tool
Sanding drum
When centering the flap servo, begin by setting
the throws at the transmitter to 0% for both
the up and down flap positions. This is done
for both 2- and 3-position flap switches.
 1. Prepare the flap servo by installing the rubber
grommets and brass eyelets as shown in the radio
or servo instructions. Center the flap servo using the
radio system. Use side cutters to remove any arms
from the horn that may interfere with the operation
of the servo.
The flap linkage will be connected to the hole in
the servo horn 1/2-inch (13mm) from the center
of the arm as illustrated in the photo above.
 2. Repeat step 1 to prepare a second flap servo.
Note the servos will be identical.
 3. Use a pencil to draw two lines on the cover. The
first line is along the bottom of the cover, 3/32-inch
(2.5mm) from the edge. The second line is 7/8-
inch (22mm) from the side of the cover as shown.
This will center the servo horn in the slot when
using the recommended servos.
 4. Sand the 10mm x 7mm end of the block using
medium grit sandpaper. This will be the end glued
to the plate in the following step.