User Manual

EN
6
V900
™
Battery Installation and ESC Arming
1. Lower the throttle and throttle trim to the lowest settings. Power on the
Transmitter, then wait 5 seconds.
2. Lift the hatch from the back to remove.
3. For added security, apply the loop side (soft side) of the optional hook and
loop tape (B) to the bottom of your battery and the hook side to the
battery tray.
4. Install the fully charged battery (C) in the middle of the battery
compartment, as shown. Secure using the hook and loop strap (D).
5. Connect the battery to the ESC (the ESC is now armed).
6. Keep the aircraft immobile and away from wind, upright and on a at
surface or the system will not initialize.
• The ESC will produce a series of sounds. 3 or 4 at tones indicating
cell count followed immediately by a single tone indicating the ESC is
armed.
• An LED will light on the receiver.
7. Reinstall the battery hatch.
A
B
Optional
C
D
Battery Selection
The E-ite V900™ aircraft is 3S and 4S capable. Choose the battery that ts
your ying style.
1800mAh 14.8V 4S 30C+ Li-Po Battery is recommended for good speed and
longer ight times.
The E-ite
®
Thrust
®
1800mAh 14.8V 4S 35C Li-Po Battery (EFLRB18004S35)
is recommended for top speeds.
Refer to the Optional Parts List for other recommended
batteries. If using a battery other than those listed, the battery should be
within the range of capacity, dimensions and weight of the E-ite Li-Po battery
packs to t in the fuselage.
Be sure the model balances at the recommended CG before ying.
4S = Crazy Fast
3S = Fast
CAUTION: Always keep hands away from the propeller. When
armed, the motor will turn the propeller in response to any
throttle movement.
NOTICE: The ESC has the motor brake enabled to prevent damage to
the propeller during landing.