User Manual

4 E-flite Beechcraft Staggerwing 480 ARF Assembly Manual
Contents of Kit/Parts Layout
Replacement Parts
EFL612501 Fuselage
EFL612502 Upper Wing
EFL612503 Lower Wing
EFL612504 Tail Set
EFL612505 Cowling
EFL612506 Canopy Hatch
EFL612507 Landing Gear Set
EFL612508 Spinner
EFL612509 Plastic Mounts
EFL612510 Interplane Struts
EFL612511 Scale Details
EFL612512 Pushrod Set
Hardware/Accessory Sizes
Wheel diameter 2-inch (52mm)
Wing bolts 3mm x 25mm machine screw
Recommended Radio Equipment
You will need a minimum 5-channel transmitter,
receiver and four servos.
Recommended Complete Radio System
SPM6625 DX6i DSMX 6CH system
Or Purchase Separately
SPMAR6115 AR6115 6CH DSMX
®
Receiver
EFLRDS76 DS76 Digital Sub-Micro
Servo (4)
EFLREX6L 6-inch (152mm) Lightweight
Servo Extension (for ailerons)
Park 480 Motor Setup
EFLM1505 Park 480 1020Kv
EFLA1040L 40-Amp Lite Pro Switch-Mode
BEC Brushless ESC
EFLB21003S 2100mAh 3S 14.8V 20C Li-Po,
12AWG EC3
EFLP1080E 10 x 8 Propeller (included)
EFLM1924L Prop Adapter with
Collet Long, 4mm (optional)
Optional Accessories
EFLA110 Power Meter
EFLC3020 Celectra 200W DC Multi-
Chemistry Battery Charger
EFLAEC312 Charge Lead with 12-inch
Wire and Jacks, 16AWG
Optional Retracts
EFLGP0150 90 Degree Main Micro
Pneumatic Retract Set
EFLRDS76 DS76 Digital Sub-Micro Servo
ROB164G 100 PSI Hand Air Pump
with Gauge
Required Tools and Adhesives
Tools & Equipment
Felt-tipped pen Flat file
Pencil Pin vise
Pliers Ruler
Sandpaper Side cutters
Hobby scissors
Drill bit: 1/16-inch (1.5mm)
Hex wrench: 1.5mm, 3/32-inch
Hobby knife with #11 blade
Phillips screwdriver: #0, #1, #2
Optional Tools & Equipment
Balancing stand (optional)
Adhesives
Medium CA PAAPT02
Thin CA PAAPT08
Silicone adhesive PAAPT12
Threadlock PAAPT42
Binding the Radio System
Before starting the assembly of your model, we
recommend preparing your radio system for
installation. This includes charging the transmitter and
receiver batteries, as well as centering the trims and
sticks on your transmitter. If using a computer radio,
make sure to reset a model memory and name it for
this particular model. We also recommend binding
the transmitter and receiver at this time, following the
instructions provided with your radio system.
 We highly recommend re-binding
the radio system once all the control
throws are set. This will keep the servos
from moving to their endpoints until the
transmitter and receiver connect.