User Manual

EN
Wing Installation
Mount the Wing to the Fuselage
1. Insert the wing joiner into the fuselage.
2. Slide the wing onto the wing joiner.
3. Thread the included nylon thumb screws into position as shown to secure the
wing in place. the Longer screws go in the front positions
3mm x 16mm Nylon
Thumb Screw
3mm x 20mm Nylon
Thumb Screw
Model Assembly Continued
Cargo Door Operation
The Twin Cargo airplane features a cargo door connected to Channel 5 (BNF).
CAUTION: Always confi rm the Center of Gravity remains within acceptable
limits when adding or dropping cargo. Never fl y the Twin Cargo airplane
with the Center of gravity outside of the recommended range.
CAUTION: Adjust the Channel 5 end points so the servo is not over-driven
trying to close the door. If the servo is straining trying to move the door past
the closed position, it will cause excess current draw and could cause a BEC
failure, which would result in loss of control and a crash.
2x for Rear2x for Front
6
EC-1500 1.5m
Receiver Installation (PNP)
The Spektrum AR636 receiver is recommended for ths airplane. If you choose
to install another receiver, ensure that it is at least a 5-channel full range (sport)
receiver. Refer to your receiver manual for correct installation and operation
instructions.
Installation (AR636 shown)
1. Mount the receiver parallel to the length of the fuselage as shown. Use double-
sided servo tape.
CAUTION: Incorrect installation of the receiver could cause a crash.
2. Attach the appropriate control surfaces to the their respective ports on the
receiver using the chart in the illustration.
AR636 Port
Assignments
BND/PRG = BIND
1 = Throttle
2 = Y-harness: Ailerons
3 = Elevator
4 = Rudder
5 = Cargo Door
6 = Y-harness: Flaps