User Manual

ManualsBrandsE-flite ManualsAircraftsEC-1500 Twin (White-red)

Model Assembly

Horizontal Tail Installation

1. Slide the horizontal stabilizer tube (A) into the hole in the rear of the fuselage.

2. Install the two piece (left and right) horizontal stabilizer as shown.

3. Press the halves in place until the stabilizers snap in position.

Press the button on the bottom of the stabilizer to disengage for removal

Vertical Tail Installation

1. Connect the rudder servo to the servo extension in the fuselage.

2. Slide the vertical tail into place and verify the integrated servo connectors make a

good connection.

3. Secure the vertical tail with two 2mm x 20mm self tapping screws.

2 x 20mm

Self-tapping

button head

EC-1500 1.5m

Preﬂ ight

SAFE

Select Technology (BNF Basic)

The BNF Basic version of this airplane includes SAFE Select technology which can

offer an extra level of protection in ﬂ ight. Use the following instructions to make the

SAFE Select system active and assign it to a switch. When enabled, SAFE Select

prevents the airplane from banking or pitching past predetermined limits, and

automatic self-leveling keeps the airplane ﬂ ying in a straight and level attitude when

the aileron, elevator and rudder sticks are at neutral.

SAFE Select is enabled or disabled during the bind process. When the airplane is

bound with SAFE Select enabled, a switch can be assigned to toggle between SAFE

Select mode and AS3X mode. AS3X

technology remains active with no banking

limits or self leveling any time SAFE Select is disabled or OFF.

SAFE Select can be conﬁ gured three ways;

• SAFE Select Off: Always in AS3X mode

• SAFE Select On with no switch assigned: Always in SAFE Select mode

• SAFE Select On with a switch assigned: Assigned switch toggles between

SAFE Select mode and AS3X mode

1. Remove and inspect contents.

2. Read this instruction manual thoroughly.

3. Charge the ﬂ ight battery.

4. Setup Transmitter using transmitter setup chart.

5. Fully assemble the airplane.

6. Install the ﬂ ight battery in the aircraft (once it has been fully charged).

7. Check the Center of Gravity (CG).

8. Bind the aircraft to your transmitter.

9. Make sure linkages move freely.

10. Test the ﬂ ap operation.

11. Perform the Control Direction Test with the transmitter.

12. Perform the AS3X Control Direction Test with the aircraft.

13. Adjust ﬂ ight controls and transmitter.

14. Perform a radio system Range Test.

15. Find a safe open area to ﬂ y.

16. Plan ﬂ ight for ﬂ ying ﬁ eld conditions.