User Manual

37E-flite DHC-2 Beaver ARF Assembly Manual
 15. Repeat Steps 11 through 14 to install the 24
7
/
8
-inch
(631mm) elevator pushrod wire.
Note: If you are planning on installing floats, skip Steps
16 and 17 as they pertain to the installation of the tail
wheel linkage.
 16. Place a clevis retainer on a nylon clevis and thread
the clevis on the remaining pushrod wire. Slide the wire
into the pushrod tube inside the fuselage and through the
pushrod connector of the rudder servo. Secure the clevis
to the tail wheel control horn.