User Manual

25E-flite DHC-2 Beaver ARF Assembly Manual
Note: The following steps will be performed while
you have epoxy mixed. Make sure the steps can
be performed before the epoxy begins to cure. It is
suggested to make a test run of the steps if you are
unsure of the procedure.
 4. Mix up some 30-minute epoxy and apply it to one half
of the joiner. Make sure to coat the top, bottom and both
sides of the joiner.
 5. Coat the root rib of the wing panel with epoxy. Apply
epoxy into the opening for the joiner as well.
 6. Slide the joiner into the wing panel. Apply epoxy to
the joiner and to the wing as described in Step 5 and
slide the two wing panels together.