User Manual

9E-flite Shoestring 15e ARF Assembly Manual
 6. Secure the servo using the screws provided with
the servo and a #1 Phillips screwdriver. The output
shaft of the servo will align with the opening in the
cover. Center the aileron servo using the radio system.
 7. Use a pin vise and 5/64-inch (2mm) drill bit
to enlarge the hole in the servo arm 1/2 inch
(13mm) from the center of the servo horn. Remove
the arms from the servo horn that will not be used
using side cutters.
 8. Fit the servo horn to the servo so it is
perpendicular to the servo. Use side cutters
to remove the arms that do not protrude
through the cover.
 9. Use string or dental floss to secure a 6-inch
(152mm) servo extension to the aileron servo lead.
 10. Tie the string around the extension. Use the
string to pull the extension through the wing root.
 11. Apply 1–2 drops of thin CA in each of the
holes to harden the surrounding wood for the
aileron cover screws.