Supplementary Document

Action Card For SAFE+ GPS Features* EN
Flight Modes
Flight Mode TX Switch Position
Beginner FM 0 (Green LED)
Intermediate FM 1 (Blue LED)
Advanced FM 2 (Red LED)
Holding Pattern*
*
Press and release HP/AL(Bind)
AutoLand*
*
Press and hold (3seconds)
HP/AL (Bind)
*GPS module (SPMA3173 ) required, not included
Virtual Fence Selection (Mode 2 transmitter shown)
Compass Calibration
Deactivating GPS
**Changing the flight mode switch or pressing the HP/AL
(bind) button will interrupt Holding Pattern or AutoLand Modes.
Hold the transmitter sticks as shown any time after GPS
acquisition and before a home location is set to change the
active Virtual Fence Mode.
Virtual Fence OFF
• Low throttle
• Full right aileron
• Full up elevator
Circle Virtual Fence, Small (Default)
175m radius from home location
• Low throttle
• Full left aileron
• Full up elevator
Circle Virtual Fence, Large
225m radius from home location
• Low throttle
• Full left aileron
• Full down elevator
Airfield Virtual Fence
400m long x 200m wide flight area with
no fly zone set 10m from the home location
• Low throttle
• Full right aileron
• Full down elevator
Airfield Virtual Fence requires the additional selection of a flying
area direction based on the specified home location.
Compass calibration must be performed before the first flight
with GPS and when flying at a new location. Refer to the
product manual for complete compass calibration instructions.
Push and hold the HP/AL (bind) button and fully cycle the flight
mode switch 3 times. Power cycle the aircraft to re-activate.
Yellow LED
flashing
Yellow LED flashing,
red LED flash once
Yellow LED flashing,
red LED flash twice
Yellow LED flashing,
red LED flash three times

Summary of content (8 pages)