User manual EFL-EFL2475

Available from: www.modelflight.com.au
Required
Par
ts
Co
wling
Installation
1. Solder any connectors to the speed control to
connect
to the motor batter y and motor if necessar y . Connect
the
ESC
to
the
motor
and
secure
it
to
the
bottom
of
the
motor
Fuselage
w/motor
installed
Cowling
2mm x 8mm wood screw (4)
Propeller
Spinner
Prop adapter (for outrunner motor)
Electronic speed control
Required T ools and Adhesives
Screwdriver (Phillips #0)
Hook and loop material
Important Infor mation About Y our Br ushless ESC
Make sure your ESC brake is programmed to Off. Also, be
sure
to use an ESC with the proper 9V cutof f when using 3-cell Li-
Po
packs, or 6V cutof f when using 2-cell Li-Po packs.
box using hook and loop material. Actual ESC
location
may
vary
but
proper
air
flow
and
cooling
is
impor
tant.
Important
Infor
mation
About
Y
our
Propeller
It is also ver y impor tant to check to be sure the propeller is
balanced before installing onto the shaft. An unbalanced
propeller may strip the gears or cause poor flight characteristics.
2. Connect the speed control to the radio system and
motor batter y . Check that the motor is rotating in the
correct direction. It will rotate counterclockwise when
viewed from the front of the aircraft. Use the
instructions
with your speed control to correct a motor that is
operating
in
the
wrong
direction.
E-flite
Extra
260
480
ARF
Assembly
Manual
11