User Manual

 7. Attach the micro control connector to both

servo arms. Be sure to use the included retainer

to secure the micro control connector to the

servo arms.

Note: Use the long 3D servo arms included

with your servos to provide the greatest

amount of throw.

 8. Turn on the radio system and center the aileron

trim and stick. Make sure the aileron servo is

operating properly using the transmitter. Slide the

pushrod wire through the micro connector. Install

the servo arm 90-degrees to the servo. Center the

aileron, and secure the position of the wire using

the 2mm x 4mm screw and a Phillips screwdriver.