User Manual

Control Surface Centering

Control Horn and Servo Arm Settings

Factory Settings

Horns Arms

Elevator

Rudder

Ailerons

Flaps

The table to the right shows the factory settings for the control horns and servo

arms. Fly the aircraft at factory settings before making changes.

After ﬂ ying, you may choose to adjust the linkage positions for the desired

control response. See the table to the right.

IMPORTANT: If control throws are changed from the factory settings, the

AR636 gain values may need to be adjusted. Refer to the Spektrum AR636

manual for adjustment of gain values.

After assembly and transmitter setup, conﬁ rm that the control surfaces are

centered. If the control surfaces are not centered, mechanically center the

control surfaces by adjusting the linkages.

After binding a transmitter to the aircraft receiver, set the trims and

sub-trims to 0, then adjust the linkages to center the control surfaces.

More control throw Less control throw