User Manual

Model Assembly Continued

Horizontal Stabilizer Installation Continued

4. Attach the Z-bend end of the control rod (cc) (from Bag B) to the servo

arm’s center hole as shown.

5. Attach the clevis (dd) to the elevator control horn’s second to outer most

hole as shown.

6. Ensure the elevator servo arm is in the correct position, then adjust the

linkage to center the elevator.

When needed, disassemble in reverse order.

Wing Installation

Wing Assembly

1. Slide both wing tubes into the wing holes. The long tube (aa) is installed

in the front hole and the short tube (bb) is installed in the rear hole.

2. Ensure that the aileron, flap and gear servo wires pass through the

square hole (cc) to the top side of the wing.

3. Secure the wing together by installing two brackets (dd) where the two

wing halves join as shown.