Extra 300 1.
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product.
EN Box Contents Quick Start Information Set up your transmitter using the transmitter setup chart Transmitter Setup Travel and Dual Rates Hi Rate 100% Low Rate 70% Ail 50mm (2 in) 30mm (1.5 in) Ele 60mm (2.38 in) 45mm (1.75 in) Rud 100mm (4 in) 70mm (2.75 in) Center of Gravity (CG) 3.5 – 4.0 in (90 –100 mm) from leading edge of wing at the fuselage.
EN SAFE® Select Technology (BNF Basic) The evolutionary SAFE® Select technology can offer an extra level of protection so you can perform the first flight with confidence. No complex transmitter programming is required. Just follow the simple bind process to make the SAFE Select system active. When activated, bank and pitch limitations keep you from over-controlling and automatic self-leveling makes recovery from risky or confusing attitudes as simple as releasing the sticks.
EN Model Assembly Landing Gear Installation 1. Fit the landing gear into the slot. 2. Install the landing gear cover and secure using four 3 x 15 mm screws. Tail Installation 2 Horizontal Stabilizer 1. Insert the horizontal stabilizer tube into one of the stab halves. 2. Slide the halves together into the fuselage. Key the mating elevator parts together snugly. 1 3. Install two 3 x 15 mm screws to secure the stab halves. 4.
EN Model Assembly Continued Wing Installation 1. Remove the magnetic bottom hatch cover. 2. Slide the wing joiner into one of the wing panels. Insert that panel into the wing opening in the fuselage and install the other wing panel onto the wing joiner. Make sure the aileron servo leads from each wing are routed inside the wing saddle and out the bottom hatch. 2 3 3. Secure the wing panels to the fuselage using four 3 x 30 mm screws. Propeller Installation 1.
EN Model Assembly Continued PNP Receiver Selection and Installation The Spektrum™ AR636 receiver is recommended for this airplane. If you choose to install another receiver, ensure that it is at least a 4-channel full range receiver. Refer to your receiver manual for correct installation and operation instructions. 1 = Throttle 2 = Aileron 3 = Elevator 4 = Rudder Installation (AR636 shown) 1. Remove the magnetic bottom hatch cover. 2. Mount the receiver parallel to the length of the fuselage as shown.
EN Transmitter and Receiver Binding / Enabling and Disabling SAFE Select (BNF Basic) This product requires an approved Spektrum™ DSM2®/DSMX® compatible transmitter. Visit www.bindnfly.com for a complete list of approved transmitters. Switching ON SAFE Select Binding Sequence The aircraft has an optional SAFE Select feature, which can be switched ON or OFF easily by binding in a specific manner as described below.
EN Battery Installation and ESC Arming Battery Selection The Spektrum™ 2200mAh 14.8V 4S 30C Li-Po battery (SPMX22004S30) is recommended. Refer to the Optional Parts List for other recommended batteries. If using a battery other than those listed, the battery should be within the range of capacity, dimensions and weight of the Spektrum Li-Po battery packs to fit in the fuselage. Be sure the model balances at the recommended CG before flying. 1. Lower the throttle and throttle trim to the lowest settings.
EN SAFE® Select Switch Designation SAFE® Select technology can be easily assigned to any open switch (two or three position) on the transmitter. With this new feature, you now have the flexibility to switch SAFE On and Off while in flight. Mode 1 and 2 Transmitters IMPORTANT: Before assigning your desired switch, ensure that the travel for that channel is set at 100% in both direction. Assigning a switch 1. Bind the aircraft correctly to activate SAFE Select.
EN Center of Gravity (CG) The CG location is measured from the leading edge of the wing at the root. This CG location has been determined with the recommended Li-Po battery (SPMX22004S30). 90 –100 mm +/- 3mm back from leading edge of wing at the fuselage. Tip: Measure the CG with the aircraft inverted. NOTICE: Install the battery but do not connect the ESC while checking the CG. Personal injury may result. AS3X Control Direction Test (BNF Basic) Aircraft movement AS3X Reaction 1.
EN Flying Tips and Repairs Consult local laws and ordinances before choosing a flying location. Range Check your Radio System Before you fly, range check the radio system. Refer to your specific transmitter instruction manual for range test information. Oscillation Once the AS3X system is active (after advancing the throttle for the first time), you will normally see the control surfaces react to aircraft movement.
EN Post Flight 1. Disconnect the flight battery from the ESC (Required for Safety and battery life). 2. Power OFF the transmitter. 3. Remove the flight battery from the aircraft. 4. Recharge the flight battery. 5. Repair or replace all damaged parts. 6. Store the flight battery apart from the aircraft and monitor the battery charge. 7. Make note of the flight conditions and flight plan results, planning for future flights.
EN Troubleshooting Guide Problem Possible Cause Throttle not at idle and/or throttle trim too high Aircraft will not respond to throttle Throttle servo travel is lower than 100% but responds to Throttle channel is reversed other controls Motor disconnected from ESC Damaged propeller and spinner, collet or motor Extra propeller noise or extra vi- Propeller is out of balance bration Prop nut is too loose Flight battery charge is low Propeller installed backwards Reduced flight time or aircraft Flight battery
EN AMA National Model Aircraft Safety Code Effective January 1, 2014 A. GENERAL B. RADIO CONTROL A model aircraft is a non-human-carrying aircraft capable of sustained flight in the atmosphere. It may not exceed limitations of this code and is intended exclusively for sport, recreation, education and/or competition. All model flights must be conducted in accordance with this safety code and any additional rules specific to the flying site. 1.
EN Limited Warranty What this Warranty Covers Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase. or assistance, please visit our website at www.horizonhobby.com, submit a Product Support Inquiry, or call the toll free telephone number referenced in the Warranty and Service Contact Information section to speak with a Product Support representative.
EN Contact Information Country of Purchase United States of America Horizon Hobby Address Horizon Service Center (Repairs and Repair Requests) servicecenter.horizonhobby.com/ RequestForm/ Horizon Product Support (Product Technical Assistance) productsupport@horizonhobby.com 877-504-0233 websales@horizonhobby.com 800-338-4639 2904 Research Rd Champaign, Illinois, 61822 USA Horizon Technischer Service service@horizonhobby.
Recommended Receivers • Empfohlene Empfänger Récepteurs Recommandés • Ricevitori Raccomandati PNP Only • Nur PNP • PNP Uniquement • Solo PNP Part # | Nummer Numéro | Codice SPMAR610 SPMAR6600T SPMAR6270T SPMAR8010T SPMAR9030T SPMAR636 SPMAR7350 SPMAR9350 AR610 6-Channel Coated Air Receiver Telemetry Equipped Receivers Beschreibung Description Récepteur aérien avec revêtement 6 canaux AR610 Ricevente aereo AR610 6 canali con rivestimento Empfänger mit Telemetrie Récepteurs avec télémétrie Ricev
Replacement Parts • Ersatzteile • Pièces de rechange • Pezzi di ricambio Part # | Nummer Numéro | Codice EFL11576 EFL11577 EFL11578 EFL11579 EFL11580 EFL11581 EFL11582 EFL11583 EFL11584 EFL11585 EFL11586 EFL11587 EFL11588 EFL11589 EFL11590 EFL11591 EFL11592 EFL11593 EFL11594 EFL11595 EFL11596 EFL11597 EFL11598 SPMAR636 Description Fuselage w/Rudder Wing Horizontal Stabilizer Cowl Canopy Landing Gear Set Tailwheel Set Spinner Battery Cover Bottom Cover Linkage Rod Screw Set Wing Tube Decal Sheet Landing Gea
Optional Parts • Optionale Bauteile • Pièces optionnelles • Pezzi opzionali Part # | Nummer Numéro | Codice EFLA250 EFLAEC302 EFLAEC303 SPMX22004S30 EFLB32004S30 SPMX22003S30 SPMX32003S30 KXSB32004S40 Beschreibung Description Descrizione Park Flyer Tool Assortment, 5 pc EC3 Battery Connector, Female (2) EC3 Device/Battery Connector, Male/Female 14.4V 4S 30C 2200mAh Li-Po IC3 14.4V 4S 30C 3200mAh Li-Po 11.1V 3S 30C 2200mAh LiPo IC3 11.1V 3S 30C 3200mAh Smart LiPo IC3 14.
Extra 300 1.m © 2018 Horizon Hobby, LLC. E-flite, the E-Flite logo, DSM, DSM2, DSMX, Bind-N-Fly, BNF, the BNF logo, Plug-N-Play, AS3X, SAFE, the SAFE logo, ModelMatch, Passport, Prophet, EC3, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. Futaba is a registered trademark of Futaba Denshi Kogyo Kabushiki Kaisha Corporation of Japan.
