Beechcraft D18 1.5m Manual

EN
Beechcraft D18 1.5m
16
Motor Service
CAUTION: Always disconnect the flight battery before performing motor service.
Disassembly
1. Remove the spinner (A), propeller (B), 4 screws (M3 x 8mm machine screws)
(C) and prop adapter (D) from the motor shaft.
2. Remove 2 screws (2 x 6mm self tapping screws) (E), 1 screw (2 x 24mm self
tapping screw) located in the bottom dummy engine cylinders (F), and remove
the cowl (G).
3. Remove the 4 screws (M3 x 12mm) (H) from the motor mount (I).
4. Remove the motor and motor mount from the fuselage.
5. Disconnect the motor wires from the ESC wires.
6. Remove the 4 screws (M3 x 10mm) (J), 4 lock washers (K) and motor (L) from
the motor mount.
Assembly
Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC wires.
• Install the propeller as shown.
• Tighten the spinner by using screwdriver in the hole in the
spinner nut. Turn both spinners clockwise to tighten.
A
B
D
E
G
L
H
I
J
9.5 X 7.5
EFLP09575CCW EFLP09575CW
Control Surface Replacement Servo Description Replacement Adhesive
Aileron
SPMSA382 A382 14g Sub-Micro MG Servo Deluxe Materials Foam 2 Foam (DLMAD34)
Elevator
Rudder
Flaps
Servo Service
C
F
K
Rotation direction is referenced as if you are sitting in the cockpit