Beechcraft D18 1.5m Manual
EN
13
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
After flying, you may choose to adjust the linkage positions for the desired control
response. See the table to the right.
Control Horn and Servo Arm Factory Settings
Control Horns Servo Arms
Elevator
Rudder
Ailerons
Flaps
Tail Wheel
More control throw Less control throw
High Rate Low Rate
Aileron
p = 18mm
q = 18mm
p = 12mm
q = 12mm
Elevator
p = 18mm
q = 16mm
p = 13mm
q = 11mm
Rudder
= 20mm
= 20mm
= 15mm
= 15mm
Flaps
Partial Full
q = 20mm q = 32mm
Dual Rates and Control Throws
Program your transmitter to set the rates and control throws to the values given.
These values have been tested and are a good starting point to achieve successful
flight.
After flying, you may choose to adjust the values for the desired control response.
To
Bellcrank
From Rudder
Servo