User Manual

Center of Gravity (CG)

The CG location is measured from the leading edge of the wing at the root.

This CG location has been determined with the recommended Li-Po battery

(EFLB32006s30) installed in the middle of the battery compartment.

120mm

back from

leading edge

at the root.

Control Direction Test

Move the controls on the transmitter to make sure the aircraft control surfaces

move correctly and in the proper direction or reverse a servo.

After performing the Control Test, correctly set the failsafe. Make sure the

transmitter controls are at neutral and the throttle and throttle trim are in the

low position, then rebind the airplanes to your transmitter. If the receiver loses

its connection to the transmitter, the failsafe will drive the servos to the settings

made at binding.

Control Horn and Servo Arm Settings

The tabe to the right shows the factory settings for the control horns and servo

arms. Fly the aircraft at factory settigns before making changes.

Factory Settings

Horns Arms

Elevator

Rudder

Ailerons

Flaps