T-28 Trojan 1.1m Manual

EN
7
Transmitter Setup (BNF Basic)
IMPORTANT: After you set up your model, always rebind the transmitter and
receiver to set the desired failsafe positions.
Dual Rates
Attempt your first flights in low rate. For landings, use high rate elevator.
NOTICE: To ensure AS3X technology functions properly, do not lower rate values
below 50%. If less control deflection is desired, manually adjust the position of
the pushrods on the servo arm
NOTICE: If oscillation occurs at high speed, refer to the Troubleshooting Guide
for more information.
Exponential (Expo)
After first flights, you may adjust expo in your transmitter.
†
Some of the terminology and function locations used in the iX12 and iX20
programming may be slightly different than other Spektrum AirWare
™
radios.
The names given in parenthesis correspond to the iX12 and iX20 programming
terminology. Consult your transmitter manual for specific information about
programming your transmitter.
Computerized Transmitter Setup
Start all transmitter programming with a blank ACRO model (perform a model reset),
then name the model.
Set Dual Rates to HIGH 100% LOW 70%
Set Servo Travel to 100%
Set Throttle Cut to -100%
Set Retract Channel to Reverse
Set Aileron Expo to High Rate 15% Low Rate 5%
Set Elevator Expo to High Rate 10% Low Rate 5%
Set Rudder Expo to High Rate 10% Low Rate 5%
DXe Refer to spektrumrc.com for the appropriate download setup.
DX7S
DX8
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set WING TYPE: 1 AIL
DX6e
DX6 (Gen2)
DX7 (Gen2)
DX8e
DX8 (Gen2)
DX9
DX10t
DX18
DX20
iX12
iX20
1. Go to the SYSTEM SETUP (Model Utilities)
†
2. Set MODEL TYPE: AIRPLANE
3. Set AIRCRAFT TYPE (Model Setup, Aircraft Type)
†
:
WING: 1 AIL
PNP Receiver Selection and Installation
The recommended receiver for this aircraft is the Spektrum AR631.
If you choose to install a different receiver, it needs to be a 4-channel or more
full range (sport) receiver. Refer to the manual of your chosen receiver for correct
installation and operation instructions.
AR631 Installation
1. Remove the hatch on the top of the fuselage.
2. Attach the appropriate control surfaces to their respective ports on the
receiver using the table at the right.
3. Using double-sided servo tape, mount the receiver to the flat area behind the
ESC, as shown. The receiver should be mounted in the orientation shown,
parallel to the length of the fuselage, with the label facing up and the servo
ports facing the rear of the aircraft. The orientation of the receiver is critical for
all AS3X
®
and SAFE
®
technology setups.
CAUTION: Incorrect installation of the receiver could cause a crash.
AR631 Port
Assignments
BND/PRG = BIND
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder
5 = NA
6 = NA
Antenna Installation
The AR631 receiver has a coaxial style antenna. We recommend installing the antenna
as far as possible from metal, batteries, or carbon ber to maximize signal reception
performance.
NOTICE: Do not cut, kink, or modify the antennas. Damage to the coaxial portion
of an antenna will reduce the performance of the antenna. Shortening or cutting off
the 31mm tip will reduce the range.
Active portion
of antenna