User Manual

The recommended receiver for this aircraft is the Spektrum AR636. If you choose

to install a different receiver, ensure that it is at least a 6-channel full range (sport)

receiver. Refer to the manual of your chosen receiver for correct installation and

operation instructions.

AR636 Installation

1. Slide the canopy latch (A) back and lift the back of the canopy to remove the

canopy from the fuselage.

2. Attach the appropriate control surfaces to the their respective ports on the

receiver using the table at the right.

3. Using double-sided servo tape,(not included) mount the receiver to the ﬂ at area

behind the battery compartment, as shown. The receiver should be mounted

in the orientation shown, parallel to the length of the fuselage, with the label

facing up and the servo ports facing the rear of the aircraft. The orientation of

the receiver is critical for all AS3X

and SAFE

technology setups.

CAUTION: Incorrect installation of the receiver could cause a crash.

PNP Receiver Selection and Installation

1 = Throttle

2 = Aileron

3 = Elevator

4 = Rudder/Nose Wheel

5 = Retracts

6 = Speed Brake

Optional Scale Missiles Installation

The included optional scale missiles are easily installed and removed without the

use of tools.

• The missile are installed on the inner wing and fuselage mounting points.

To install the missiles:

1. Insert the tabs of the missiles in the enlarged end of the mounting point slots.

2. Slide toward the back of the aircraft to lock the tabs in the slots.

To remove the missiles, slide them forward and pull the tabs out of the

mounting slots.