User Manual

14 E-flite Diamante 25e ARF Assembly Manual
  18. Plug the servo into the receiver and power up the
radio system. Center the aileron stick and trim. Install
a long servo arm onto the servo, parallel to the aileron
hinge line. Mark the pushrod wire where it crosses the
servo horn using a felt-tipped pen.
  19. Bend the wire 90 degrees at the mark made in the
last step. Use a pushrod wire connector to secure the wire
to the servo arm. Trim any excess wire using side cutters.
  20. Repeat Steps 9 through 19 to complete the
aileron servo installation.
Landing Gear Installation
Required Parts
• Fuselage • Landing gear (left and right)
• 2
1
/
4
in (57mm) wheel (2) • Wheel pant (left and right)
• 6-32 lock nuts (6) • 6-32 x 1
1
/
8
" machine screw (2)
• #6 washer (4) • 4-40 x 1/2" machine screw (2)
• 4-40 blind nut (2)
• 6-32 x 3/8" socket head screws (4)
Required Tools and Adhesives
• Drill • Drill bit: 9/64 in (3.5mm)
• Adjustable wrench • Adjustable pliers
• #1 Phillips screwdriver • Hex wrench: 3/32", 7/64"
• Felt-tipped pen
  1. Attach the landing gear to the bottom of the fuselage
using four 6-32 x 3/8" socket head screws. The gear will
only go on in one direction.