EFL4850 Commander mPd Manual

Model Assembly

Horizontal Tail Installation

1. Slide the horizontal tail (A) into the slot in the rear of the fuselage. Ensure

the control horn faces down.

2. Secure the horizontal tail piece in place using the included 2 screws (B).

Use caution to avoid over-tightening the screw.

3. Attach the ball link to the elevator control horn using the included screw and

nut (see instructions for clevis connection).

Tip: Use needle-nose pliers or ball link pliers (RV01005) to remove or install a

link on a control horn

Landing Gear Installation

1. Install the landing gear assembly (A) into the pocket located at the bottom

of the fuselage as shown.

2. Secure the landing gear into place with the 2 included screws (B)

(4 x 40mm screws) as shown.

Disassemble in reverse order.

4X 40mm