Cherokee 1.3m Manual

EN
Model Assembly Continued
Propeller Installation
1. Install the Prop adapter, propeller, prop washer and nut.
2. Tighten the nut until the prop adaptor grasps the propeller shaft securely.
3. Secure the spinner with a 3 x 8mm screw.
Disassemble in reverse order.
Horizontal Tail Installation
1. Remove the three 1.5 x 8mm self tapping screws holding the tail cover in place.
2. Locate the horizontal stabilizer on the elevator pivot assembly, and secure it
to the assembly with two 3 x 8mm screws
3. Install the tail cover and secure it in place with the screws.
3 x 8mm
Phillips head machine
1.5 x 8mm
Phillips head
self tapping
6
Piper Cherokee 1.3m
3 x 8mm
Phillips head machine
Control Surface Centering
After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of
the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and sub-trims
to 0, then adjust the clevis to center the control surfaces.
• Turn the linkage clockwise or counterclockwise until the control surface is centered.
• Attach the linkage to the servo arm or control horn after adjustment.