Cherokee 1.3m Manual

EN
Model Assembly
Landing Gear Installation
Main Gear
1. Insert the main landing gear wires into the landing gear mounting brackets
on the bottom of the wings.
2. Secure the main gear into place with the retainers and the 4 included
2 x 16mm screws, as shown.
Nose Gear
1. Insert the nose gear into the steering assembly.
2. Locate the hole for the nose gear wire in the steering assembly so the nose
gear slides into position when the spring is compressed.
3. Align the threaded hole in the brass insert on the nose gear wire with
the screw hole in the exposed plastic bracket at the base of the steering
assembly. Insert the 1.5 x 4mm screw to secure the nose gear.
4. Align the screw hole in the scissor assembly with the hole in the exposed
bracket at the base of the steering assembly. Install the 1.5 x 8mm screw to
secure the scissor assembly in place.
Wing Installation
IMPORTANT: The integrated servo connectors are in the wing and fuselage.
Ensure that they slide together correctly.
1. Slide the wing tube into the fuselage.
2. Slide the wings onto the wing tube.
3. Secure the wing halves into position using the included 3 x 8mm screws.
Disassemble in reverse order.
5
1.5 x 8mm
Phillips head machine
1.5 x 4mm
Phillips head machine
2 x 16mm
Phillips head machine
3 x 8mm
Phillips head machine