User Manual

Motor and Speed Control Installation

Required Parts

• Airframe • Receiver

• 3mm x 5mm screw (4) • 3mm washer (2)

• Prop adapter • Hook and loop material

• 10-amp electronic speed control

• Propeller (10 x 3.8 recommended)

• Brushless outrunner motor (EFLM1200 recommended)

Required Tools and Adhesives

• Foam-safe CA

• Phillips screwdriver (small)

• Hex wrench, 3/32"

Note: It is very important to check to be sure

the propeller is balanced before installing onto

the shaft.

 1. To use an E-flite

™

Outrunner, the shaft of the

motor must exit the fixed part of the motor

instead of through the rotating portion. You will

have to change this. Loosen the setscrew in the

rotating part of the motor. Slide the shaft though

the motor and tighten the setscrew.

Note: Please follow the instructions included

with your E-flite Outrunner motor for

repositioning of the propeller shaft.