Instructions for Use

Binding is the process of programming the receiver of

the control unit to recognize the GUID (Globally Unique

Identiﬁ er) code of a single speciﬁ c transmitter.The

transmitter is bound to the model at the factory.

To bind or re-bind your heli to your transmitter, please

follow the directions below:

MLP4DSM Binding Procedure

1. Disconnect the ﬂ ight battery from the helicopter.

2. Center all trims on your transmitter (refer to transmitter control section below for trim instructions).

3. Power off the transmitter and move the throttle stick to the down/off position.

4. Connect the ﬂ ight battery in the helicopter. The LED on the 5-in-1 Control unit ﬂ ashes after 5 seconds.

5. Push in on the left stick while powering on the transmitter

(you will hear a mechanical ‘click’ when pushing in the stick).

6. Release the left stick and immediately move it to the Low Throttle position. The transmitter will beep and the

power LED will blink.

7. The helicopter is bound when the blue LED on the 5-in-1 unit turns solid.

8. Disconnect the ﬂ ight battery and power the transmitter off.

If you encounter problems, obey binding instructions

and refer to the troubleshooting guide for other

instructions.

If needed, contact the appropriate Horizon Product

Support ofﬁ ce. For a list of compatible DSM

transmit-

ters, please visit www.bindnﬂ y.com.

Transmitter and Receiver Binding